Oil Change Reminder Lamp: Service and Repair

Engine Oil Replacement Reminder Light

This light acts as a reminder to replace the engine oil.

This light will come on when the ignition key is turned to "ON" and will go off after about a few seconds.

When you drive for about 7200 km (4500 miles) after the engine oil replacement, this light illuminates for about 3 seconds and then flashes for about 12 seconds with the ignition key turned to the "ON" position. If you continue driving without replacing the engine oil, and if the distance driven exceeds 8000 km(5000 miles), the light will come on. The light will remain on thereafter.

If the light is flashing, we recommend that you replace the engine oil at an early opportunity depending on the driving and road conditions. If the light comes on, replace it as soon as possible.

Resetting the system


The system must be reset after the engine oil replacement. Reset the system by the following procedure:


1. Press the "POWER" switch to the "OFF mode with the odometer reading shown.

2. Press the "POWER" switch twice to select the "IG-ON" mode while holding down the trip meter reset button.

Hold down the button for at least 5 seconds. The odometer indicates "000000" and the light goes off.

If the system fails to reset, the light will remain flashing.


Navigation Maintenance Item Setting (If equipped)

When the navigation system is turned on, the "Information" screen displays when it is time to replace a part or certain components.

1. Push the "INFO" button.

2. Touch "Maintenance"

3. Touch the desired button.

"Delete All": To cancel all conditions which have been input.

"Reset All" : To reset the item which has satisfied a condition.

If "ON" is selected, the system gives maintenance information with the "Information" screen when the system is turned on.

If "OFF" is selected, the "Information" screen is disabled.

When the vehicle needs to be serviced, the touch screen button color will change to orange.

4. Input the conditions.

Notice of "Date": The next maintenance date can be input.

Notice of "Distance": The driving distance until the next maintenance check can be input.

"Delete": To cancel the date and distance conditions.

"Reset": To reset the date and distance conditions.

5. Touch "OK" The screen returns to the "Maintenance" screen.


Note:

- For scheduled maintenance information, please refer to the Scheduled maintenance guide or Owners manual supplement.

- Depending on your driving or the road conditions, the system may have a time-lag between the data which has been input and the actual date and driving distance.