Without Scan Tool

DTC CHECK (WHEN USING SST CHECK WIRE)

Check DTC




1. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST 09843-18040

2. Turn the ignition switch ON.




3. Read the DTC from the ABS warning light and VSC OFF indicator light on the combination meter.

HINT: If no code appears, inspect the TC and CG terminal circuit, and the ABS warning light and VSC OFF indicator light circuits.

Trouble Area
TC and CG terminal circuit
ABS warning light circuit
VSC OFF indicator light circuit




4. As examples, refer to the chart for the blinking patterns of the normal system code and trouble codes 11 and 21.
5. Codes are explained in the code table.
6. After completing the check, disconnect terminals 13 (TC) and 4 (CG) of the DLC3.

If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.

END OF DTC CHECK

a. Turn the ignition switch to the ON position.
b. Check that the ABS warning light and VSC OFF indicator light go off within approximately 3 seconds.