Rear Door Lock (For Hatchback)

Rear Door Lock (for Hatchback):

Rear Door Lock (for Hatchback):

Rear Door Lock (for Hatchback):

REAR DOOR LOCK (for Hatchback)

REMOVAL

HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure listed below is for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

4. REMOVE REAR DOOR SERVICE HOLE COVER

5. REMOVE REAR DOOR CHECK ASSEMBLY

6. REMOVE REAR DOOR WEATHERSTRIP

7. REMOVE REAR DOOR BELT MOULDING

8. REMOVE REAR DOOR GLASS RUN

9. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

10. REMOVE REAR DOOR QUARTER WINDOW WEATHERSTRIP

11. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

12. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY (w/ Power Window)

13. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY (w/o Power Window)




14. REMOVE REAR DOOR LOCK ASSEMBLY
a. Using "Torx" socket wrench T30, remove the 3 screws.
b. Move the rear door lock downward, remove the outside handle frame release plate and remove the rear door lock.




c. Disengage the 7 claws and open the 2 covers.




d. Disconnect the rear door lock remote control cable and the rear door inside locking cable.
e. Remove the door lock wire harness seal.

INSTALLATION

1. INSTALL REAR DOOR LOCK ASSEMBLY

NOTE:
- If reusing a door lock that has been removed, replace the packing in the connecting part with new.
- Make sure that no grease and dirt adheres to the packing surface in the connecting part.

a. Apply MP grease to the sliding and rotating areas of the front door lock.




b. Connect the rear door lock remote control cable and the rear door inside locking cable.




c. Engage the 7 claws and close the 2 covers.
d. Insert the door lock into the outside handle frame release plate, then set it onto the door panel.
e. Make sure that the outside handle frame link is securely engaged with the door lock.
f. Apply adhesive to the threads of the screws.
Adhesive: Part No. 08833-00070, THREE BOND 1324 or the equivalent




g. Using "Torx" socket wrench T30, install the rear door lock with the 3 screws.

Torque: 5.0 N.m (51 kgf.cm, 44 in.lbf)

2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY (w/ Power Window)

3. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY (w/o Power Window)

4. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

5. INSTALL REAR DOOR QUARTER WINDOW WEATHERSTRIP

6. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

7. INSTALL REAR DOOR GLASS RUN

8. INSTALL REAR DOOR BELT MOULDING

9. INSTALL REAR DOOR WEATHERSTRIP

10. INSTALL REAR DOOR CHECK ASSEMBLY

11. INSTALL REAR DOOR SERVICE HOLE COVER

12. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

13. INSTALL DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)