For Hatchback

POWER STEERING ECU (for Hatchback)

COMPONENTS (Part 1):

COMPONENTS (Part 2):

COMPONENTS (Part 3):

REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE INSTRUMENT PANEL FINISH PANEL END LH
3. REMOVE INSTRUMENT PANEL FINISH PANEL END RH
4. REMOVE INSTRUMENT CLUSTER FINISH PANEL
5. REMOVE COMBINATION METER ASSEMBLY
6. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
7. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

HINT: Use the same procedure for the RH side as for the LH side.

8. REMOVE FRONT PILLAR GARNISH RH
9. REMOVE FRONT PILLAR GARNISH LH
10. REMOVE NO. 1 SWITCH HOLE BASE
11. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
12. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

13. REMOVE POWER STEERING ECU
(a) Separate the wire harness clamp.

(b) Disconnect the 4 connectors.

1. INSTALL POWER STEERING ECU
(a) Install the power steering ECU with the 2 nuts.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)

(b) Connect the 4 connectors.

(c) Install the wire harness clamp.

NOTICE: Make sure that the wire harness of the steering column assembly is installed onto the power steering ECU bracket and that it is not pulled too tightly.

2. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
3. INSTALL NO. 1 SWITCH HOLE BASE
4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
5. INSTALL FRONT PILLAR GARNISH RH
6. INSTALL FRONT PILLAR GARNISH LH
7. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH
8. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

HINT: Use the same procedure for the RH side as for the LH side.

9. INSTALL COMBINATION METER ASSEMBLY
10. INSTALL INSTRUMENT CLUSTER FINISH PANEL
11. INSTALL INSTRUMENT PANEL FINISH PANEL END RH
12. INSTALL INSTRUMENT PANEL FINISH PANEL END LH
13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
14. PERFORM CALIBRATION OF TORQUE SENSOR ZERO POINT.