Power Window Regulator Motor (For Hatchback Front Side)

POWER WINDOW REGULATOR MOTOR (For Hatchback Front Side)

Power Window Regulator Motor (For Hatchback Front Side):

REMOVAL

HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure described below is for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE DOOR ARMREST COVER
3. REMOVE FRONT ARMREST BASE PANEL UPPER
4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
5. REMOVE FRONT DOOR WINDOW FRAME FRONT MOULDING
6. REMOVE FRONT DOOR WINDOW FRAME REAR MOULDING (for 3 Door)
7. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
8. REMOVE FRONT DOOR BELT MOULDING
9. REMOVE FRONT DOOR SERVICE HOLE COVER
10. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
11. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY

12. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY FRONT
a. Using "Torx" socket wrench T25, remove the 3 screws and the power window regulator motor.

INSTALLATION

1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY FRONT
a. Apply MP grease to the sliding and rotating areas of the regulator motor.
b. Using "Torx" socket wrench T25, install the power window regulator motor assembly front with the 3 screws.

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)

2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY
3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
4. INSTALL FRONT DOOR SERVICE HOLE COVER
5. INSTALL FRONT DOOR BELT MOULDING
6. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY
7. INSTALL FRONT DOOR WINDOW FRAME REAR MOULDING (for 3 Door)
8. INSTALL FRONT DOOR WINDOW FRAME FRONT MOULDING
9. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
10. INSTALL FRONT ARMREST BASE PANEL UPPER
11. INSTALL DOOR ARMREST COVER
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)