Removal

2AZ-FE ENGINE CONTROL SYSTEM: ECM:

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (Removal)

3. REMOVE AIR CLEANER INLET ASSEMBLY (Removal)

4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY (Removal)

5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (Removal)

6. REMOVE AIR CLEANER BRACKET

(a) Remove the 2 bolts and air cleaner bracket.
7. DISCONNECT ECM CONNECTOR
(a) Disconnect the 2 ECM connectors.

(1) Raise the levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

NOTE: After disconnecting the connector, make sure that dirt, water and other foreign matter does not contact the connecting part of the connector.

8. REMOVE ECM

(a) Remove the 3 bolts of the ECM with bracket.
(b) Remove the ECM with bracket.