Installation

1GR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR






(a) Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
(b) Install the crankshaft position sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7.4 ft-lbf)
(c) Connect the crankshaft position sensor connector.
2. INSTALL COOLER COMPRESSOR ASSEMBLY






(a) Install the cooler compressor assembly with the 4 bolts.
Torque: 24.5 Nm (250 kgf-cm, 18 ft-lbf)
(b) Connect the cooler compressor assembly connector.






(c) Install the suction hose sub-assembly with the bolt.
Torque: 7.8 Nm (80 kgf-cm, 69 in-lbf)
3. INSTALL GENERATOR ASSEMBLY
Refer to the procedures up to "INSTALL GENERATOR ASSEMBLY" Installation
4. INSTALL FAN
Refer to the procedures up to "INSTALL FAN" Installation.
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 in-lbf)