Removal

1GR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE FAN
Refer to the procedures up to "REMOVE FAN " Removal.
3. REMOVE GENERATOR ASSEMBLY
Refer to the procedures up to "REMOVE GENERATOR ASSEMBLY" Removal
4. SEPARATE COOLER COMPRESSOR ASSEMBLY





(a) Remove the bolt, then separate the suction hose sub-assembly.






(b) Disconnect the cooler compressor assembly connector.
(c) Remove the 4 bolts, then separate the cooler compressor assembly from the V-ribbed belt tensioner assembly.






5. REMOVE CRANKSHAFT POSITION SENSOR
(a) Disconnect the crankshaft position sensor connector.
(b) Remove the bolt, then remove the crankshaft position sensor.