Main Relay (Computer/Fuel System): Testing and Inspection

2GR-FE ENGINE CONTROL SYSTEM: INTEGRATION RELAY: INSPECTION

INSPECTION

1. INSPECT ENGINE ROOM JUNCTION BLOCK ASSEMBLY





(a) Inspect the EFI No. 1 fuse.
(1) Remove the EFI No. 1 fuse.
(2) Using an ohmmeter, measure the resistance of the fuse.
Standard resistance:






(b) Inspect the A/F fuse.
(1) Remove the A/F fuse.
(2) Using an ohmmeter, measure the resistance of the fuse.
Standard resistance:






(c) Inspect EFI relay.





(1) Measure the resistance according to the value(s) in the table below.
Standard resistance:





NOTE: While using the battery for the inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.

(d) Inspect the C/OPN relay.





(1) Measure the resistance according to the value(s) in the table below.
Standard resistance:





NOTE: While using the battery for the inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.

(e) Inspect the A/F relay.





(1) Measure the resistance according to the value(s) in the table below.
Standard resistance:





NOTE: While using the battery for the inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.