Security Lamp/Indicator: Testing and Inspection

THEFT DETERRENT: SECURITY INDICATOR LIGHT ASSEMBLY: INSPECTION

INSPECTION

1. INSPECT SECURITY INDICATOR LIGHT
(a) Disconnect the D40 ECU connector, with the E19 indicator connector connected (w/ Smart Key System).






(b) Disconnect the D10 ECU connector, with the D49 indicator connector connected (w/o Smart Key System).
(c) Apply battery voltage from the wire harness back side between the terminals of the indicator, and check the lighting condition of the security indicator.
Standard :

w/ Smart Key System





w/o Smart Key System





NOTICE:
- If the positive (+) lead and the negative (-) lead are incorrectly connected, the security indicator will not come on.
- Voltage of more than 12 V will damage the security indicator.
- If the voltage is too low, the security indicator will not come on.
If the result is not as specified, replace the passenger belt and airbag indicator.