Installation

2GR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR
(a) Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.






(b) Install the crankshaft position sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(c) Connect the crankshaft position sensor connector.
2. TEMPORARILY TIGHTEN COMPRESSOR AND MAGNETIC CLUTCH

3. INSTALL COMPRESSOR AND MAGNETIC CLUTCH

4. CONNECT SUCTION HOSE SUB-ASSEMBLY

5. CONNECT DISCHARGE HOSE SUB-ASSEMBLY

6. INSTALL RADIATOR ASSEMBLY AND FAN ASSEMBLY WITH MOTOR Installation

7. INSTALL COOLER CONDENSER ASSEMBLY Installation

8. INSTALL UPPER RADIATOR SUPPORT SUB-ASSEMBLY Installation

9. INSTALL HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)

10. INSTALL HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)

11. INSTALL RADIATOR GRILLE

12. CONNECT COOLING FAN ECU CONNECTOR Installation

13. CONNECT OIL COOLER HOSE Installation

14. CONNECT NO. 2 RADIATOR HOSE Installation

15. CONNECT NO. 1 RADIATOR HOSE Installation

16. INSTALL NO. 1 AIR CLEANER INLET Installation

17. INSTALL NO. 2 AIR CLEANER INLET Installation

18. INSTALL BATTERY Installation

19. INSTALL COOL AIR INTAKE DUCT SEAL Installation

20. CHARGE WITH REFRIGERANT

21. ADD ENGINE COOLANT Service and Repair

22. INSPECT FOR COOLANT LEAK Testing and Inspection

23. INSPECT AUTOMATIC TRANSAXLE FLUID
HINT:

24. INSPECT FOR OIL LEAK
25. WARM UP ENGINE

26. INSPECT FOR REFRIGERANT LEAK

27. INSTALL NO. 1 ENGINE UNDER COVER Installation

28. INSTALL ENGINE UNDER COVER ASSEMBLY Installation

29. INSTALL V-BANK COVER SUB-ASSEMBLY Installation