B1662

SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: B1662/45: Indicator Light Circuit Malfunction

DTC B1662/45 - Indicator Light Circuit Malfunction

DESCRIPTION

The indicator light circuit consists of the center airbag sensor and the combination meter.
When the center airbag sensor detects a malfunction in the SRS airbag system, the SRS warning light comes on to inform the driver. It also comes on when the source voltage drops, and automatically goes off in approximately 10 seconds after the source voltage returns to normal (DTC is not stored).
The SRS warning light comes on for 6 seconds after the engine switch is turned on (IG) and goes off if the system is normal.
When an open circuit is detected, such as when the connector between the combination meter and the center airbag sensor is disconnected, the SRS warning light remains on even when approximately 6 seconds elapsed after the engine switch is turned on (IG).
DTC B1662/45 is stored when a malfunction is detected in the indicator light circuit.






WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK CAN COMMUNICATION SYSTEM
(a) Check if a CAN communication DTC is output Diagnosis System.

Result





B -- REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
A -- Continue to next step.
2. CHECK BATTERY
(a) Measure the voltage of the battery.
Standard Voltage:
11 to 14 V
NG -- CHECK AND REPLACE BATTERY OR CHARGING SYSTEM
OK -- Continue to next step.
3. CHECK CONNECTORS
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
(c) Check that the connectors are properly connected to the center airbag sensor and combination meter.
OK:
The connectors are properly connected.
NG -- CONNECT CONNECTORS PROPERLY
OK -- Continue to next step.
4. CHECK HARNESS AND CONNECTOR (SOURCE VOLTAGE OF CENTER AIRBAG SENSOR)





(a) Disconnect the connectors from the center airbag sensor.
(b) Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
(c) Turn the engine switch on (IG).
(d) Operate all the components of the electrical system (defogger, wipers, headlights, heater blower, etc.).
(e) Measure the voltage according to the value(s) in the table below.
Standard Voltage:






NG -- REPLACE HARNESS AND CONNECTOR
OK -- Continue to next step.
5. CHECK HARNESS AND CONNECTOR (SOURCE VOLTAGE OF COMBINATION METER)





(a) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
(b) Disconnect the E7 connector from the combination meter.
(c) Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
(d) Measure the voltage according to the value(s) in the table below.
Standard Voltage:






NG -- REPLACE HARNESS AND CONNECTOR
OK -- Continue to next step.
6. CHECK SRS WARNING LIGHT (SHORT TO GROUND)
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
(c) Connect the connector to the combination meter.
(d) Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
(e) Turn the engine switch on (IG).
(f) Check the SRS warning light condition.
OK:
After the primary check period, SRS warning light goes off for approximately 10 seconds and then remains on.
HINT: The primary check period is approximately 6 seconds after the engine switch is turned on (IG).

NG -- GO TO METER / GAUGE SYSTEM
OK -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY