Installation

EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION

INSTALLATION
HINT: A bolt without a torque specification is shown in the standard bolt chart .





1. INSTALL FRONT UPPER CENTER BUMPER RETAINER
(a) Install the bumper retainer with the 3 bolts.
2. INSTALL HEADLIGHT ASSEMBLY LH Installation

3. INSTALL HEADLIGHT ASSEMBLY RH
HINT: Use the same procedures described for the LH side.





4. INSTALL FRONT BUMPER SIDE SUPPORT LH
(a) Attach the 3 clips to install the side support.
(b) Install the 2 screws.
5. INSTALL FRONT BUMPER SIDE SUPPORT RH
HINT: Use the same procedures described for the LH side.





6. INSTALL FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY LH
(a) Install the bumper extension with the 4 nuts.
Torque: 67 Nm (683 kgf-cm, 49 ft-lbf)
7. INSTALL FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY RH
HINT: Use the same procedures described for the LH side.





8. INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
(a) Install the reinforcement with the 6 nuts.
Torque: 71 Nm (724 kgf-cm, 52 ft-lbf)






9. INSTALL FRONT BUMPER ENERGY ABSORBER
(a) Install the energy absorber.
10. INSTALL FRONT BUMPER COVER





(a) w/ Headlight Cleaner System:
Connect the headlight cleaner hose.
(b) Connect the No. 4 engine room wire and attach the 10 claws to install the bumper cover.
(c) Install the 3 clips, 4 screws and 4 bolts.





(d) Using a T30 "TORX" socket, install the 6 screws.





11. INSTALL RADIATOR GRILLE ASSEMBLY Installation

12. INSTALL UPPER RADIATOR SUPPORT SEAL Installation







13. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
(a) Push in the clip indicated by the arrow in the illustration to install the fender splash shield.
(b) Install the 3 bolts and screw.
14. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
HINT: Use the same procedures described for the LH side.