Reassembly

EXTERIOR PANELS / TRIM: FRONT BUMPER: REASSEMBLY

REASSEMBLY
HINT: When installing the front bumper protector, heat the front bumper surface using a heat light.

Standard:

NOTE: Do not heat the front bumper excessively.

1. INSTALL FRONT NO. 2 BUMPER PROTECTOR
(a) Clean the front bumper surface.
(1) Using a heat light, heat the front bumper surface.
(2) Remove the double-sided tape from the front bumper.
(3) Wipe off any tape adhesive residue with cleaner.

(b) Install a new bumper protector.
(1) Remove the peeling paper from the face of 2 new bumper protectors.
HINT: After removing the peeling paper, keep the exposed adhesive free from foreign matter.
(2) Install the 2 bumper protectors as shown in the illustration.
3. INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH (w/ Headlight Cleaner System) Installation

4. INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH (w/ Headlight Cleaner System)
HINT: Use the same procedures described for the LH side.

5. INSTALL TYPE 1 HEADLIGHT WASHER NOZZLE SUB-ASSEMBLY LH (w/ Headlight Cleaner System) Installation

6. INSTALL TYPE 1 HEADLIGHT WASHER NOZZLE SUB-ASSEMBLY RH (w/ Headlight Cleaner System)
HINT: Use the same procedures described for the LH side.

7. INSTALL LOWER RADIATOR GRILLE LH
(a) Attach the 7 claws to install the lower radiator grille.
(b) w/ Headlight Cleaner System:
Attach the 2 headlight cleaner hose clamps.
8. INSTALL LOWER RADIATOR GRILLE RH
HINT: Use the same procedures described for the LH side.

9. INSTALL FOG LIGHT ASSEMBLY LH Installation

10. INSTALL FOG LIGHT ASSEMBLY RH
HINT: Use the same procedures described for the LH side.

11. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System) Installation

12. INSTALL NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System) Installation

13. INSTALL NO. 4 ENGINE ROOM WIRE
(a) w/o Intuitive Parking Assist System:
Install the No. 4 engine room wire.
(1) Attach the 9 clamps to install the engine room wire.
(2) Connect the 2 connectors.

(b) w/ Intuitive Parking Assist System:
Install the No. 4 engine room wire.
(1) Attach the 9 clamps to install the engine room wire.
(2) Connect the 4 connectors.