Reassembly

SLIDING ROOF / CONVERTIBLE: SLIDING ROOF HOUSING: REASSEMBLY

REASSEMBLY

1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY
(a) Hold down the window deflector.
NOTE: Make sure that the spring indicated by the arrow in the illustration is securely installed.









(b) Using a screwdriver, slide the drive cable in the direction indicated by the arrow in the illustration to install it.
HINT: Tape the screwdriver tip before use.





(c) Slide the rear roof drip channel forward and attach the 2 claws to install it.






(d) Install the 2 stoppers with the 2 screws.






2. ADJUST SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY
(a) Using a screwdriver, align the matchmarks by sliding the drive cable in the directions indicated by the arrow in the illustration.
HINT: Tape the screwdriver tip before use.

3. INSTALL SLIDING ROOF SUNSHADE STOPPER LH






(a) Install the stopper.
4. INSTALL SLIDING ROOF SUNSHADE STOPPER RH
HINT: Use the same procedures described for the LH side.

5. INSTALL SUNSHADE TRIM SUB-ASSEMBLY






(a) Insert the sunshade trim into the sliding roof housing.
(b) Attach the 4 claws to install the sliding roof piece LH and RH.
(c) Install the 2 screws.
6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY





(a) Install the drive gear and room light bracket with the 2 bolts.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)






(b) Attach the bracket claw to install the bracket.
7. INSTALL SLIDING ROOF LOCK CATCH PLATE LH