Removal

3UR-FE ENGINE CONTROL: ECM: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. DISCONNECT CONNECTOR HOLDER BLOCK






(a) Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.
3. REMOVE ECM
(a) Raise the 2 levers while pushing the locks on the 2 levers.
NOTE: Make sure that the lock levers are raised 90° as shown in the illustration before disconnecting the connectors. Failure to do this may cause the connectors to break.





(b) Disconnect the 2 connectors.






(c) Remove the 4 bolts and ECM.
4. REMOVE GASKET






(a) Peel off the gasket.






(b) Spray gasket remover or equivalent on the remaining tape of the gasket.
NOTE: When using gasket remover or equivalent, cover the ECM connectors with a cloth.





(c) Remove the tape of the gasket without using bladed objects.