Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Driver Side): INSTALLATION

INSTALLATION

1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY






(a) Connect the connector.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Install the driver side knee airbag with the 5 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Installation

3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

4. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation

5. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation

6. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH Installation

7. INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION Installation

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.