Disassembly

BRAKE: REAR DISC BRAKE:

COMPONENTS





DISASSEMBLY

1. REMOVE REAR DISC BRAKE CYLINDER MOUNTING COLLAR
(a) Remove the 2 cylinder mounting collars from the disc brake cylinder.
2. REMOVE REAR DISC BRAKE BUSH DUST BOOT
(a) Remove the 3 bush dust boots.
3. REMOVE CYLINDER BOOT





(a) Using a screwdriver, remove the set ring and cylinder boot.
4. REMOVE REAR DISC BRAKE PISTON
(a) Place a piece of cloth or similar, between the piston and the disc brake cylinder.





(b) Use compressed air to remove the piston from the disc brake cylinder.

CAUTION: Do not place your fingers in front of the piston when using compressed air.

NOTE: Do not spatter the brake fluid.

5. REMOVE PISTON SEAL





(a) Using a screwdriver, remove the piston seal from the brake cylinder.

NOTE: Do not damage the inner cylinder and the cylinder groove.

6. REMOVE REAR DISC BRAKE BLEEDER PLUG
(a) Remove the disc brake bleeder plug cap and bleeder plug from the rear disc brake cylinder.
7. REMOVE REAR DISC
(a) Make matchmarks on the rear disc and the axle hub.
(b) Remove the rear disc.