Rear Wheel Alignment

SUSPENSION: REAR WHEEL ALIGNMENT:

NOTICE: For Zero Point Calibration information, please refer to: TSB T-SB-0020-8 (3/25/08).

ADJUSTMENT

1. INSPECT TIRES
(Component Tests and General Diagnostics)
2. MEASURE VEHICLE HEIGHT (Service and Repair)

3. INSPECT TOE-IN
If the toe-in is not within the specified range, inspect the suspension parts and replace parts if necessary.





(a) Inspect the toe-in.
Toe-in:
USA, Canada





Mexico





4. INSPECT CAMBER





(a) Install a camber-caster-kingpin gauge or put the wheels on a wheel alignment tester.
(b) Inspect the camber.

Camber:
USA, Canada





Mexico





If the measured value is not within the specified range, inspect the suspension parts for damage and wear. Replace parts as necessary because camber cannot be properly adjusted with any damaged or worn parts.