Removal

2UZ-FE ENGINE CONTROL: CAMSHAFT POSITION SENSOR: REMOVAL

REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE
(a) Service Precautions

2. REMOVE NO. 1 ENGINE UNDER COVER Replacement

3. DRAIN ENGINE COOLANT Service and Repair

4. REMOVE THROTTLE BODY COVER SUB-ASSEMBLY Removal

5. REMOVE DRIVE BELT Removal

6. DISCONNECT NO. 1 RADIATOR HOSE Removal

7. REMOVE NO. 3 TIMING BELT COVER SUB-ASSEMBLY LH Removal

8. REMOVE CAMSHAFT POSITION SENSOR






(a) Remove the bolt, stud bolt and camshaft position sensor.
9. REMOVE FRONT WIPER AIM AND BLADE ASSEMBLY RH Removal

10. REMOVE FRONT WIPER AIM AND BLADE ASSEMBLY LH Removal

11. REMOVE FRONT FENDER TO COWL SIDE SEAL RH Removal

12. REMOVE FRONT FENDER TO COWL SIDE SEAL LH Removal

13. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Removal

14. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY Removal

15. REMOVE FRONT COWL TOP OUTER PANEL SUB-ASSEMBLY Removal

16. REMOVE AIR CLEANER HOSE ASSEMBLY Removal

17. DISCONNECT VACUUM HOSE ASSEMBLY Removal

18. REMOVE NO. 2 WATER BY-PASS PIPE Removal

19. REMOVE EFI FUEL PIPE CLAMP
20. DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY Removal

21. DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY Removal

22. REMOVE INTAKE MANIFOLD Removal

23. REMOVE VVT SENSOR
(a) Disconnect the 2 VVT sensor connectors.






(b) Remove the 2 bolts and remove the 2 VVT sensor connectors.