Operation CHARM: Car repair manuals for everyone.
Home >> Toyota >> 2008 >> Sequoia 2WD V8-4.7L (2UZ-FE) >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Power Steering Pressure Switch >> Testing and Inspection
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Power Steering Pressure Switch: Testing and Inspection








2UZ-FE ENGINE CONTROL: POWER STEERING OIL PRESSURE SWITCH: ON-VEHICLE INSPECTION

ON-VEHICLE INSPECTION

1. INSPECT POWER STEERING OIL PRESSURE SENSOR
(a) Check the power steering oil pressure sensor.
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream main switch on.
(4) Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Power Steering Pressure.
(5) Start the engine.
(6) Operate the steering wheel while idling, and read the value on the Techstream.
Standard:






If not as specified, check for DTCs DTC Check / Clear. If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure sensor.
Inspect the power steering system On-Vehicle Inspection. If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure sensor.
pro multis · About Operation CHARM