Installation

1GR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR:

INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR
(a) Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
(b) Install the crankshaft position sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7.4 in-lbf)
(c) Connect the crankshaft position sensor connector.
2. INSTALL COOLER COMPRESSOR ASSEMBLY
(a) Install the cooler compressor assembly with the 4 bolts.
Torque: 25 Nm (255 kgf-cm, 18 ft-lbf)
(b) Connect the cooler compressor assembly connector.
(c) Install the suction hose sub-assembly with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
3. INSTALL GENERATOR ASSEMBLY (Service and Repair)

4. INSTALL FAN SHROUD (Installation)

5. INSTALL V-BANK COVER (Installation)

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 in-lbf)