Installation

2UZ-FE CHARGING: GENERATOR: INSTALLATION

INSTALLATION

1. INSTALL GENERATOR ASSEMBLY
(a) Install the generator with the bolt and nut.
Bolt - Torque: 39 Nm (400 kgf-cm, 29 ft-lbf)
Nut (M10) - Torque: 39 Nm (40 kgf-cm, 29 ft-lbf)
Nut (M8) - Torque: 16 Nm (158 kgf-cm, 11 ft-lbf)
(b) Connect the generator connector.
(c) Connect the generator wire with the nut and rubber cap.
Torque: 9.8 Nm (100 kgf-cm, 86 in-lbf)
(d) Install the generator wire clamp to the cord clip on the generator.

2. INSTALL VANE PUMP ASSEMBLY
(a) Install the vane pump assembly with the nut and 2 bolts.
Nut - Torque: 43 Nm (438 kgf-cm, 32 ft-lbf)
Bolt - Torque: 43 Nm (438 kgf-cm, 32 ft-lbf)
(b) Connect the vacuum hose.

3. INSTALL FAN WITH FLUID COUPLING
(a) Put the fan w/ fluid coupling and fan shroud into the engine room at the same time.
(b) Install the fan shroud with 3 bolts.
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf)
(c) Install the fan w/ fluid coupling with 4 nuts.
Torque: 29 Nm (296 kgf-cm, 21 ft-lbf)

4. INSTALL FAN AND GENERATOR V BELT Installation
5. INSTALL RADIATOR UPPER SUPPORT SEAL
6. CONNECT BATTERY NEGATIVE TERMINAL