Reassembly

E351 MANUAL TRANSAXLE: SHIFT AND SELECT LEVER SHAFT: REASSEMBLY

REASSEMBLY

1. INSTALL CONTROL SHAFT COVER OIL SEAL





(a) Using SST and a hammer, install a new control shaft cover oil seal to the control shaft cover.
SST: 09950-60010
09951-00280
SST: 09950-70010
09951-07100
Oil seal installation depth:
28.0 to 29.0 mm (1.1022 to 1.142 in.)
2. INSTALL SELECT SPRING NO. 1 SEAT SHAFT SNAP RING





(a) Using a brass bar and a hammer, install the select spring No. 1 seat shaft snap ring.
3. INSTALL NO. 1 SHIFT LEVER INNER





(a) Install the No. 1 shift lever inner to the shift interlock plate.
4. INSTALL SHIFT INTERLOCK PLATE COVER





(a) Install the shift interlock plate cover to the shift interlock plate.
5. INSTALL NO. 1 SELECT SPRING SEAT





(a) Install the No. 1 select spring seat, No. 1 select return compression spring, and shift interlock plate to the shift and select lever shaft.
6. INSTALL NO. 2 SHIFT LEVER INNER





(a) Install the No. 2 shift lever inner, No. 2 select return compression spring and No. 2 select return spring seat to the shift and select lever shaft.
(b) Hold the shift and select lever in a vise using aluminum plates.
(c) Using a brass bar and a hammer, install the select seat snap ring to the shift and select lever shaft.





(d) Using a pin punch (dia 5 mm) and a hammer, install the 2 shift inner lever slotted pins to the shift and select lever shaft.
Clearance A:
0.7 to 1.7 mm (0.0276 to 0.0669 in.)
Clearance B:
-0.4 to 0.5 mm (-0.0157 to 0.0197 in.)
7. INSTALL SELECTING BELLCRANK NO. 2 BUSHING





(a) Coat the 2 selecting bellcrank No. 2 bushings with MP grease and install them to the No. 2 selecting bellcrank.
8. INSTALL NO. 2 SELECTING BELLCRANK DUST COVER





(a) Coat the No. 2 selecting bellcrank dust cover with MP grease and install it to the No. 2 selecting bellcrank.
9. INSTALL SELECTING BELLCRANK SUPPORT SUB-ASSEMBLY





(a) Install the selecting bellcrank support sub-assembly to the No. 2 selecting bellcrank.





(b) Install the No. 2 selecting bellcrank plate washer, washer, and nut.
Torque: 12 Nm (122 kgf-cm, 9ft-lbf)
10. INSTALL NO. 1 SELECTING BELLCRANK DUST COVER





(a) Install the No. 1 selecting bellcrank dust cover to the No. 2 selecting bellcrank.
11. INSTALL CONTROL SHIFT LEVER BUSHING





(a) Install the control shift lever bushing to the No. 2 selecting bellcrank.