Inner Rear View Mirror Power Source Circuit

PARK ASSIST / MONITORING: REAR VIEW MONITOR SYSTEM: Inner Rear View Mirror Power Source Circuit

Inner Rear View Mirror Power Source Circuit

DESCRIPTION

This is the power source circuit of the inner rear view mirror assembly.

WIRING DIAGRAM





INSPECTION PROCEDURE
NOTE: Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (INNER MIRROR - BATTERY AND BODY GROUND)




(a) Disconnect the R6 inner rear view mirror assembly connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:





(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:





(d) Reconnect the inner rear view mirror assembly connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE