Entire Combination Meter Does Not Operate

METER: METER / GAUGE SYSTEM: Entire Combination Meter does not Operate

Entire Combination Meter does not Operate

DESCRIPTION

This circuit provides power to the combination meter assembly.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. CHECK FUSE (DOME, GAUGE)

(a) Remove the DOME fuse from engine room relay block No. 2.
(b) Remove the GAUGE fuse from the main body ECU.
(c) Measure the resistance.
Standard Resistance:
Below 1Ohms
(d) Reinstall the fuse.
NG -- CHECK SHORT CIRCUIT IN COMPONENTS AND WIRES CONNECTED TO FUSE
OK -- Continue to next step.
2. INSPECT COMBINATION METER ASSEMBLY

(a) Disconnect the E13 combination meter connector.
(b) Measure the resistance.
Standard resistance:

(d) Reconnect the combination meter connector.
NG -- REPAIR OR REPLACE HARNESS AND CONNECTOR
OK -- REPLACE COMBINATION METER ASSEMBLY