Cylinder Head

CYLINDER HEAD SUB-ASSEMBLY





Using several steps, uniformly install and tighten the 10 cylinder head bolts and plate washers with a bi-hexagon wrench 10 mm in the sequence shown in the illustration.
Torque 36 Nm (367 kgf-cm, 27 ft-lbf)
If any cylinder head bolts do not meet the torque specification, replace them.





Mark the front of the cylinder head bolt with paint.
Retighten the cylinder head bolts by 180° as shown.
Check that the painted marks are now at 180° from the engine front.

CYLINDER HEAD LH





Using several steps, uniformly install and tighten the 8 cylinder head bolts and plate washers with a bi-hexagon wrench 10 mm in the sequence shown in the illustration.
Torque 36 Nm (367 kgf-cm, 27 ft-lbf)
If any cylinder head bolts do not meet the torque specification, replace them.





Mark the front of the cylinder head bolt with paint.
Retighten the cylinder head bolts by 180° as shown.
Check that the painted marks are now at 180° from the engine front.