Installation

2UZ-FE ENGINE CONTROL: CAMSHAFT POSITION SENSOR: INSTALLATION

INSTALLATION





1. INSTALL VVT SENSOR
(a) Install the 2 VVT sensors with the 2 bolts.
Torque: 7.5 Nm (76 kgf-cm, 66 in-lbf)
(b) Connect the 2 VVT sensor connectors.
2. INSTALL INTAKE MANIFOLD Installation
3. INSTALL NO. 1 FUEL PIPE SUB-ASSEMBLY Installation
4. INSTALL NO. 2 FUEL PIPE SUB-ASSEMBLY Installation
5. INSTALL EFI FUEL PIPE CLAMP
6. INSTALL NO. 2 WATER BY-PASS PIPE Installation
7. CONNECT VACUUM HOSE ASSEMBLY Installation
8. INSTALL AIR CLEANER HOSE ASSEMBLY Installation
9. INSTALL CAMSHAFT POSITION SENSOR





(a) Install the camshaft position sensor with the bolt and stud bolt.
Torque: 7.5 Nm (80 kgf-cm, 66 in-lbf)
10. INSTALL NO. 3 TIMING BELT COVER SUB-ASSEMBLY LH Installation
11. CONNECT NO. 1 RADIATOR HOSE Installation
12. INSTALL DRIVE BELT Installation
13. ADD ENGINE COOLANT Service and Repair
14. INSPECT FOR COOLANT LEAK Testing and Inspection
15. INSPECT FOR FUEL LEAK Testing and Inspection
16. INSTALL NO. 1 ENGINE UNDER COVER Replacement
17. INSTALL THROTTLE BODY COVER SUB-ASSEMBLY Installation
18. INSTALL FRONT COWL TOP OUTER PANEL SUB-ASSEMBLY Installation
19. INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY Installation
20. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation
21. INSTALL FRONT FENDER TO COWL SIDE SEAL RH Installation
22. INSTALL FRONT FENDER TO COWL SIDE SEAL LH Installation
23. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation
24. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation