Removal

2UZ-FE ENGINE CONTROL: CAMSHAFT POSITION SENSOR: REMOVAL

REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE
(a) Service Precautions
2. REMOVE NO. 1 ENGINE UNDER COVER Replacement
3. DRAIN ENGINE COOLANT Service and Repair
4. REMOVE THROTTLE BODY COVER SUB-ASSEMBLY Removal
5. REMOVE DRIVE BELT Removal
6. DISCONNECT NO. 1 RADIATOR HOSE Removal
7. REMOVE NO. 3 TIMING BELT COVER SUB-ASSEMBLY LH Removal
8. REMOVE CAMSHAFT POSITION SENSOR





(a) Remove the bolt, stud bolt and camshaft position sensor.
9. REMOVE FRONT WIPER AIM AND BLADE ASSEMBLY RH Removal
10. REMOVE FRONT WIPER AIM AND BLADE ASSEMBLY LH Removal
11. REMOVE FRONT FENDER TO COWL SIDE SEAL RH Removal
12. REMOVE FRONT FENDER TO COWL SIDE SEAL LH Removal
13. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Removal
14. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY Removal
15. REMOVE FRONT COWL TOP OUTER PANEL SUB-ASSEMBLY Removal
16. REMOVE AIR CLEANER HOSE ASSEMBLY Removal
17. DISCONNECT VACUUM HOSE ASSEMBLY Removal
18. REMOVE NO. 2 WATER BY-PASS PIPE Removal
19. REMOVE EFI FUEL PIPE CLAMP
20. DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY Removal
21. DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY Removal
22. REMOVE INTAKE MANIFOLD Removal
23. REMOVE VVT SENSOR
(a) Disconnect the 2 VVT sensor connectors.





(b) Remove the 2 bolts and remove the 2 VVT sensor connectors.