Cylinder Head

CYLINDER HEAD SUB-ASSEMBLY RH (for Bank 1)

Install the 8 cylinder head bolts

Step 1:




Using a 10 mm bi-hexagon wrench, install and uniformly tighten the 8 cylinder head bolts with the plate washers in several steps in the sequence shown in the illustration.

Torque 36 Nm (367 kgf-cm, 27 ft-lbf)

If any one of the cylinder head bolts does not meet the torque specification, replace the cylinder head bolt.


Step 2:




Mark the cylinder head bolt heads with paint as shown in the illustration.
Tighten the cylinder head bolts another 90° in the sequence shown in step 1.

Step 3:
Tighten the cylinder head bolts by an additional 90° in the sequence shown in step 1.
Check that the painted marks are now facing rearward.


CYLINDER HEAD SUB-ASSEMBLY LH (for Bank 2)

Step 1:




Using a 10 mm bi-hexagon wrench, install and uniformly tighten the 8 cylinder head bolts with the plate washers in several steps in the sequence shown in the illustration.

Torque 36 Nm (367 kgf-cm, 27 ft-lbf)

If any one of the cylinder head bolts does not meet the torque specification, replace the cylinder head bolt.

Step 2:




Mark the cylinder head bolt heads with paint as shown in the illustration.
Tighten the cylinder head bolts another 90° in the sequence shown in step 1.

Step 3:
Tighten the cylinder head bolts by an additional 90° in the sequence shown in step 1.
Check that the painted marks are now facing rearward.





Install the 2 bolts in the order shown in the illustration.
Install the 2 cylinder head bolts. Using several steps, tighten the bolts uniformly in the sequence shown in the illustration.

Torque 30 Nm (306 kgf-cm, 22 ft-lbf)