Removal

PARK ASSIST / MONITORING: CLEARANCE WARNING ECU: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
- Some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

2. REMOVE INSTRUMENT SIDE PANEL RH Removal
3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH Removal
4. REMOVE CLEARANCE WARNING ECU WITH BRACKET





(a) Disconnect the ECU connectors.
NOTE: Do not apply excessive force to the wire harnesses.

(b) Remove the bolt, nut and ECU with bracket.
5. REMOVE CLEARANCE WARNING ECU





(a) Remove the 2 nuts and clearance warning ECU from the bracket.
NOTICE:
- Avoid any impact to the clearance warning ECU.
- Do not drop the ECU. If it is dropped, replace it with a new one.