Removal

PARK ASSIST / MONITORING: ULTRASONIC SENSOR (for Rear Side): REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
- Some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

2. REMOVE LICENSE PLATE LIGHT ASSEMBLY LH (for Resin Type Bumper) Removal
3. REMOVE LICENSE PLATE LIGHT ASSEMBLY LH Removal
4. REMOVE LICENSE PLATE LIGHT ASSEMBLY RH (for Resin Type Bumper) Removal
5. REMOVE LICENSE PLATE LIGHT ASSEMBLY RH Removal
6. REMOVE REAR BUMPER PAD SUB-ASSEMBLY LH Removal
7. REMOVE REAR BUMPER PLATE LH Removal
8. REMOVE REAR BUMPER PLATE RH Removal
9. REMOVE REAR BUMPER COVER (for Resin Type Bumper) Removal
10. REMOVE REAR BUMPER BAR Removal
11. REMOVE NO. 1 ULTRASONIC SENSOR

(a) While pushing down on the lever with a finger to release the one claw, detach the claw on the other side to remove the ultrasonic sensor.
HINT: The type of claw on the top and bottom of the sensor are different. Observe the claws carefully before removing the sensor.

12. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER

(a) Detach the 2 claws and remove the sensor retainer from the rear bumper.
13. REMOVE NO. 2 ULTRASONIC SENSOR

(a) Detach the 2 claws and remove the sensor retainer from the rear bumper.