Reassembly

2UZ-FE LUBRICATION: OIL PUMP: REASSEMBLY

REASSEMBLY

1. INSTALL OIL PUMP ROTOR SET





(a) Place the drive and driven rotors into the pump body with the marks facing the pump body cover side.





(b) Install the oil pump cover with the 10 screws.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
2. INSTALL OIL PUMP RELIEF VALVE





(a) Insert the relief valve and compression spring into the oil pump body hole.
(b) Install the plug.
Torque: 49 Nm (500 kgf-cm, 36 ft-lbf)
3. INSTALL FRONT CRANKSHAFT OIL SEAL





(a) Using SST and a hammer, tap in a new oil seal until its surface is flush with the oil pump body edge.
SST: 09316-60011
09316-00011
NOTICE:
- Keep the lip free from foreign matter.
- Do not tap oil seal at an angle.

(b) Apply MP grease to the oil seal lip.