Removal

2UZ-FE EXHAUST: EXHAUST PIPE (except Regular Cab Standard Deck): REMOVAL

REMOVAL
CAUTION:
- Wear protective gloves when removing the exhaust pipe.
- The exhaust pipe is extremely hot immediately after the engine has stopped.
- Confirm that the exhaust pipe has cooled down before removing it.

1. REMOVE TAILPIPE ASSEMBLY
(a) Remove the bolt, clamp and gasket.
(b) Disconnect the tailpipe from the exhaust pipe support.
2. REMOVE CENTER EXHAUST PIPE ASSEMBLY
(a) Remove the 4 bolts.
(b) Disconnect the center exhaust pipe from the 3 exhaust pipe supports.
(c) Remove the 2 gaskets from the front exhaust pipe LH and RH.
3. REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD) Removal
4. REMOVE FRONT PROPELLER SHAFT ASSEMBLY (for 4WD) Removal
5. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY
(a) Disconnect the air fuel ratio sensor connector.
(b) Disconnect the heated oxygen sensor connector.
(c) Remove the 3 nuts and gasket.
(d) Disconnect the front No. 2 exhaust pipe from the exhaust pipe support.
6. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(a) Disconnect the air fuel ratio sensor connector.
(b) Disconnect the heated oxygen sensor connector and 2 clamps.
(c) Remove the 3 nuts, front exhaust pipe and gasket.
7. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) Removal
8. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) Removal
9. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) Removal
10. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) Removal