Accelerator Pedal: Testing and Inspection

2UZ-FE ENGINE CONTROL SYSTEM: ACCELERATOR PEDAL: ON-VEHICLE INSPECTION

ON-VEHICLE INSPECTION

1. INSPECT ACCELERATOR PEDAL ROD ASSEMBLY
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Push the Techstream main switch ON.
(d) Enter the following menus: Powertrain / Engine and ECT / Data List / ETCS / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.
(e) Read the value displayed on the tester.
Accel Sensor Out No. 1:






Accel Sensor Out No. 2:





If the result is not as specified, check the accelerator pedal, wire harness or ECM.