On-Vehicle Inspection

STEERING COLUMN: STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column): ON-VEHICLE INSPECTION

ON-VEHICLE INSPECTION

1. REMOVE UPPER STEERING COLUMN COVER Removal
2. REMOVE LOWER STEERING COLUMN COVER Removal





3. INSPECT TILT MOTOR
(a) Disconnect the connector A from the multiplex tilt and telescopic ECU.
(b) Connect the positive (+) battery terminal to terminal 10 (TIM+) and the negative battery terminal to terminal 1 (TIM-) of the tilt motor connector. Then confirm that the steering wheel tilts up.
OK:
Steering wheel tilts up.
(c) Connect the negative (-) battery terminal to terminal 10 (TIM+) and the positive battery terminal to terminal 1(TIM-) of the tilt motor connector. Then confirm that the steering wheel tilts down.
OK:
Steering wheel tilts down.





4. INSPECT TELESCOPIC MOTOR
(a) Disconnect the connector B from the multiplex tilt and telescopic ECU.
(b) Connect the positive battery terminal to terminal 2 (TEM+) and the negative battery terminal to terminal 6 (TEM-) of the telescopic motor connector. Then confirm that the steering column contracts.
OK:
Steering column contracts.
(c) Connect the negative battery terminal to terminal 2 (TEM+) and the positive battery terminal to terminal 6 (TEM-) of the telescopic motor connector. Then confirm that the steering column extends.
OK:
Steering column extends.
5. INSTALL LOWER STEERING COLUMN COVER Installation
6. INSTALL UPPER STEERING COLUMN COVER Installation