Installation

A750E AUTOMATIC TRANSMISSION: TRANSMISSION WIRE: INSTALLATION

INSTALLATION

1. INSTALL TRANSMISSION WIRE
(a) Coat the O-ring of the transmission wire connector with ATF.





(b) Install the transmission wire with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)





(c) Connect the transmission wire connector.
HINT: Push up the lever until the claw of the transmission wire connector makes a connection sound.

2. CONNECT TRANSMISSION WIRE





(a) Connect the 7 connectors to the solenoid valves.
(b) Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.
for bolt A - Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
for bolt B - Torque: 11 Nm (112 kgf-cm, 8 ft-lbf)
HINT: Each bolt length is indicated below.
12 mm (0.472 in.) for bolt A
36 mm (1.41 in.) for bolt B





3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY
(a) Coat a new O-ring with ATF and install it to the oil strainer.
(b) Install the oil strainer with the 4 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)





4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY
NOTE: Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.

(a) Install a new gasket and the oil pan with the 20 bolts.
Torque: 4.4 Nm (45 kgf-cm, 39 in-lbf)
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: Some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

6. ADD AUTOMATIC TRANSMISSION FLUID
(a) Add automatic transmission fluid Procedures.