B1287

NETWORKING: LIN COMMUNICATION SYSTEM: B1287: Back Door ECU Communication Stop
B1287 - Back Door ECU Communication Stop

DESCRIPTION

This DTC is stored when LIN communication between the multiplex network door ECU (back door P/W) and main body ECU (multiplex network body ECU) stops for 10 seconds or more.

WIRING DIAGRAM

INSPECTION PROCEDURE

NOTICE:
- When using the Techstream with the ignition switch off to troubleshoot:
Connect the Techstream to the vehicle and turn a courtesy light switch on and off at 1.5 second intervals until communication between the Techstream and vehicle begins.
- Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.

HINT
When communication between the multiplex network door ECU (back door P/W) and main body ECU (multiplex network body ECU) stops, DTC B2325 is also stored.

PROCEDURE

1. CLEAR DTC

(a) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

NEXT -- Continue to next step.

2. CHECK FOR DTC

(a) Check for DTCs Reading and Clearing Diagnostic Trouble Codes.

OK:

DTC B1287 is not output.

NG -- CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - MULTIPLEX NETWORK DOOR ECU)

OK -- USE SIMULATION METHOD TO CHECK How To Proceed With Troubleshooting

3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - MULTIPLEX NETWORK DOOR ECU)

(a) Remove the main body ECU (multiplex network body ECU) from the driver side junction block assembly Removal.

(b) Disconnect the V2 multiplex network door ECU (back door P/W) connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

4. CHECK HARNESS AND CONNECTOR (MULTIPLEX NETWORK DOOR ECU - BATTERY AND BODY GROUND)

(a) Disconnect the V2 multiplex network door ECU (back door P/W) connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Text in Illustration

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

5. REPLACE MULTIPLEX NETWORK DOOR ECU

(a) Temporarily replace the multiplex network door ECU (back door P/W) with a new or normally functioning one Removal.

NEXT -- Continue to next step.

6. CLEAR DTC

(a) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

NEXT -- Continue to next step.

7. CHECK FOR DTC

(a) Check for DTCs Reading and Clearing Diagnostic Trouble Codes.

OK:

DTC B1287 is not output.

NG -- REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Removal

OK -- END (MULTIPLEX NETWORK DOOR ECU IS DEFECTIVE)