Installation

A343E AUTOMATIC TRANSMISSION / TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Install the park/neutral position switch to the manual valve shaft.

(b) Temporarily install the bolt.

(c) Install a new lock washer and the nut.

Torque : 7.0 Nm (71 kgf-cm, 62 in-lbf)

(d) Turn the control shaft lever LH clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.





(e) Align the groove with the neutral basic line.









(f) Hold the switch in position and tighten the bolt.

Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)

(g) Using a screwdriver, bend the tabs of the lock washer.

(h) Connect the switch connector.

2. ADJUST SHIFT LEVER POSITION Adjustments

3. INSPECT SHIFT LEVER POSITION Adjustments

4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY On-Vehicle Inspection