Installation

WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Front Door): INSTALLATION

1. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

NOTICE:
The regulator arm must be below the intermediate position when installing the power window regulator motor.





(a) Using a T25 "TORX" socket wrench, install the power window regulator motor with the 3 screws.

HINT
* Tighten the screws in the order shown in the illustration.
* A new front window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are installed.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH Reassembly

3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH Reassembly

4. INSTALL FRONT DOOR SERVICE HOLE COVER LH Reassembly

5. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY Installation

6. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH Reassembly

7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH Reassembly

8. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH Reassembly

9. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH Reassembly

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

11. INITIALIZE POWER WINDOW CONTROL SYSTEM

(a) Initialize the power window control system Initialization.

12. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.