Removal

FRONT SUSPENSION: FRONT STABILIZER BAR (w/ KDSS): REMOVAL

1. REMOVE FRONT WHEEL

2. REMOVE SIDE STEP ASSEMBLY LH Removal

3. REMOVE STABILIZER CONTROL VALVE PROTECTOR Removal

4. DRAIN SUSPENSION FLUID Removal

5. REMOVE LOWER FRONT BUMPER COVER Removal

6. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY Removal

7. REMOVE FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY

(a) Remove the 6 bolts and 2 member braces from the front frame assembly.





8. REMOVE FRONT STABILIZER END BRACKET

(a) Remove the 4 bolts and 2 brackets from the lower arm.





9. REMOVE FRONT STABILIZER BAR

(a) Remove the 4 bolts, 2 front stabilizer lower brackets and front stabilizer bar.





(b) Remove the 2 front stabilizer link bushes and front stabilizer lower bracket bushes from the front stabilizer bar.

10. REMOVE FRONT FENDER APRON SEAL LH

(a) Remove the 7 clips and front apron seal LH.





11. REMOVE FRAME APRON SEAL BRACKET

(a) Remove the bolt and bracket.





12. DISCONNECT NO. 1 FRONT STABILIZER CONTROL TUBE ASSEMBLY

(a) Using a union nut wrench, disconnect the 2 front stabilizer control tubes.





(b) Remove the bolt.

13. REMOVE FRONT STABILIZER WITH TUBE CYLINDER ASSEMBLY

(a) Remove the bolt, nut and front stabilizer with tube cylinder assembly.





NOTICE:
* Turn the bolt while holding the nut.
* Do not loosen or remove the flare nuts labeled A and B in the illustration.





* Do not hold the front stabilizer with tube cylinder assembly by the cylinder boot.
(b) Remove the 2 bleeder plug caps and bleeder plugs from the front stabilizer with tube cylinder assembly.

14. REMOVE FRONT STABILIZER LINK ASSEMBLY RH

(a) Remove the bolt and front stabilizer link assembly.