Installation

AXLE AND DIFFERENTIAL: FRONT AXLE HUB (for 4WD): INSTALLATION

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.
1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH

(a) Apply MP grease to a new O-ring.

(b) Install the O-ring to the axle hub.

(c) Install the dust cover and axle hub to the steering knuckle with the 4 bolts.

Torque : 80 Nm (816 kgf-cm, 59 ft-lbf)

2. INSTALL FRONT AXLE SHAFT NUT

(a) Clean the threaded parts on the drive shaft and axle shaft nut using a non-residue solvent.

(b) Install the front axle shaft nut.

Torque : 235 Nm (2396 kgf-cm, 173 ft-lbf)

(c) Install the adjusting cap and cotter pin.

3. INSTALL FRONT AXLE HUB GREASE CAP

(a) Install the axle hub grease cap.

NOTICE:
Make sure the grease cap is securely installed to the axle hub.

4. INSTALL FRONT DISC Installation

5. INSTALL DISC BRAKE CYLINDER ASSEMBLY LH Installation

6. BLEED BRAKE LINE

(a) Bleed the brake line Service and Repair.

7. CHECK FLUID LEVEL IN RESERVOIR Testing and Inspection

8. CHECK FOR BRAKE FLUID LEAKAGE

9. INSTALL FRONT WHEEL

Torque : 112 Nm (1142 kgf-cm, 83 ft-lbf)

10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

(a) Inspect and adjust the front wheel alignment Service and Repair.

11. CHECK SPEED SENSOR SIGNAL

(a) Inspect the speed sensor signal Installation.