Installation

AXLE: REAR AXLE HUB AND BEARING: INSTALLATION

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

(a) Install the hub and bearing assembly with the 4 bolts.





Torque : 80 Nm (816 kgf-cm, 59 ft-lbf)

(b) Connect the skid control sensor connector.

NOTICE:
Do not twist the sensor wire when connecting it.

2. INSPECT REAR AXLE HUB BEARING LOOSENESS Rear Axle Hub and Bearing

3. INSPECT REAR AXLE HUB RUNOUT Rear Axle Hub and Bearing

4. INSTALL REAR DISC Reassembly

5. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY Installation

6. CONNECT SKID CONTROL SENSOR CONNECTOR Installation

7. INSTALL REAR WHEEL

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)

8. CHECK ABS SPEED SENSOR SIGNAL

for BOSCH Made: Test Mode Procedure

for ADVICS Made: Test Mode Procedure