Installation

SEAT: FRONT SEAT ASSEMBLY (for Manual Seat): INSTALLATION

1. INSTALL FRONT SEAT ASSEMBLY

(a) Place the front seat assembly in the vehicle and align the adjuster pin with the hole on the vehicle side.

(b) Connect the connector and clamp.

(c) Move the front seat assembly to the rearmost position by operating the slide handle.

NOTICE:
Check that the seat is locked.

(d) Temporarily install the front seat track bracket with the 2 bolts.





(e) Move the front seat assembly fully forward by operating the slide handle.

NOTICE:
Check that the seat is locked.

(f) Temporarily install the rear seat track bracket with the 2 bolts.





(g) Move the front seat assembly to the rearmost position by operating the slide handle.

NOTICE:
Check that the seat is locked.

(h) Fully tighten the 2 bolts on the front seat track bracket in the order of the inner side bolt and then the outer side bolt.

Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)

(i) Move the front seat assembly fully forward by operating the slide handle.

NOTICE:
Check that the seat is locked.

(j) Fully tighten the 2 bolts on the rear seat track bracket in the order of the inner side bolt and then the outer side bolt.

Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)

2. INSTALL INNER SEAT TRACK BRACKET COVER

(a) Slide the inner seat track bracket cover along the seat rail toward the front of the vehicle. Engage claw A to the seat rail.





(b) Push the seat track bracket cover inner to engage claw B.

3. INSTALL SEAT TRACK COVER

(a) Slide the seat track cover along the seat rail toward the front of the vehicle. Engage claw A to the seat rail.





(b) Push the seat track cover to engage claw B.

4. INSTALL FRONT SEAT HEADREST ASSEMBLY

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. INSPECT SLIDE ADJUSTER LOCK

7. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK (for Front Passenger Seat) Programming and Relearning

8. INSPECT SRS WARNING LIGHT

Check the SRS warning light Diagnosis System.