Driver Side Seat Belt Warning Light Does Not Operate

SEAT BELT: SEAT BELT WARNING SYSTEM: Driver Side Seat Belt Warning Light does not Operate
- Driver Side Seat Belt Warning Light does not Operate

DESCRIPTION

When the ignition switch is on (IG), the center airbag sensor assembly transmits front seat inner belt state signals to the combination meter assembly through CAN. If the driver seat belt is not fastened, the combination meter assembly blinks the driver seat belt warning light. If the seat belt is fastened, the warning light goes off.

NOTICE:
The seat belt warning system uses CAN. Before troubleshooting the seat belt warning system, perform "COMMUNICATION FUNCTION CHECK" by following "HOW TO PROCEED WITH TROUBLESHOOTING" to confirm that the communication systems are normal.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK FOR DTCs

(a) Check for DTCs.

Result:





B -- GO TO AIRBAG SYSTEM

A -- GO TO CAN COMMUNICATION SYSTEM
C -- Continue to next step.

2. PERFORM ACTIVE TEST USING TECHSTREAM

(a) Operate Techstream according to the steps on the display and select "ACTIVE TEST".

Combination Meter:





OK:

Switch condition (ON/OFF) can be switched by "ACTIVE TEST".

NG -- REPLACE COMBINATION METER ASSEMBLY

OK -- END