Shift Cable: Adjustments

E351 MANUAL TRANSMISSION / TRANSAXLE: TRANSMISSION CONTROL CABLE: ADJUSTMENT

1. ADJUST TRANSMISSION CONTROL SELECT CABLE

(a) Remove the console box assembly Removal.

(b) Remove the clip and disconnect the control select cable from the shift lever assembly.





(c) Push the two claws together at the top of the transmission control cable lock piece. While holding the two claws together, push the two lugs on the bottom of the lock piece toward each other and upward to pull out the lock piece.





(d) Install the transmission control shift cable to the shift lever assembly.





(e) Install the control select cable to the shift lever assembly.

NOTICE:
* Make sure to adjust the length at the neutral shift position.
* Make sure that the lock piece is protruding from the adjuster case.
(f) Install the clip to the shift lever assembly.

(g) Press in and lock the lock piece to the adjuster case.

NOTICE:
Securely press in the lock piece until the lock engages.