Sound Signal Circuit Between Radio Receiver And Television Display Assembly

AUDIO / VISUAL: AUDIO AND VISUAL SYSTEM: Sound Signal Circuit between Radio Receiver and Television Display Assembly
- Sound Signal Circuit between Radio Receiver and Television Display Assembly

DESCRIPTION

The television display assembly sends a sound signal to the radio receiver through this circuit.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier, radio receiver, or speakers.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - TELEVISION DISPLAY ASSEMBLY)

(a) Disconnect the radio receiver and the television display assembly connectors.





(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

2. INSPECT TELEVISION DISPLAY ASSEMBLY

(a) Reconnect the television display assembly connector.





(b) Check the waveform according to the conditions shown in the table below.

Standard:





NG -- REPLACE TELEVISION DISPLAY ASSEMBLY

OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE Problem Symptoms Table