Part 2

INTERIOR: ROOF HEADLINING: REMOVAL (Continued)

76. REMOVE REAR SEAT SIDE GARNISH CAP (w/ Rear Air Conditioning System)

(a) Remove the screw.

(b) Disengage the 6 claws and the guide, and remove the rear seat side garnish cap.

77. REMOVE DECK SIDE TRIM COVER RH

HINT
Use the same procedure for the RH side and the LH side.

78. REMOVE DECK SIDE TRIM RH

HINT
Use the same procedure for the RH side and the LH side.

79. REMOVE SIDE TRIM COVER RH (w/o Rear Automatic Air Conditioning System)

(a) Disengage the 4 claws and remove the side trim cover RH.

80. REMOVE REAR ROOM TEMPERATURE SENSOR (w/ Rear Automatic Air Conditioning System) Removal

81. REMOVE REAR COMBINATION LIGHT SERVICE COVER RH

(a) Using a screwdriver, disengage the 6 claws and the 2 guides, and remove the rear combination light service cover RH.

HINT
Tape the screwdriver tip before use.

82. REMOVE ROPE HOOK ASSEMBLY (for RH Side)

HINT
Use the same procedure for the RH side and the LH side.

83. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

HINT
Use the same procedure for the No. 1 luggage compartment trim hook and the No. 2 deck side trim hook.

84. REMOVE FRONT DECK SIDE TRIM COVER RH

HINT
Use the same procedure for the RH side and the LH side.

85. DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH

HINT
Use the same procedure for the RH side and the LH side.

86. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH

(a) Remove the 3 bolts.

(b) Remove the 2 clips.

(c) Disengage the 7 claws and 4 clips, and remove the deck trim side panel assembly RH.

87. REMOVE QUARTER PILLAR GARNISH RH

HINT
Use the same procedure for the RH side and the LH side.

88. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY RH (w/o Rear No. 2 Seat)

HINT
Use the same procedure for the RH side and the LH side.

89. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY RH (w/ Rear No. 2 Seat)

HINT
Use the same procedure for the RH side and the LH side.

90. REMOVE ROOF CONSOLE BOX ASSEMBLY

(a) Using a moulding remover, disengage the 2 clips, 3 guides and fastener.

(b) Disconnect the connector and remove the roof console box assembly.

91. REMOVE VISOR BRACKET COVER (for LH Side)

(a) Using a moulding remover, disengage the 4 claws and remove the visor bracket cover.

92. REMOVE VISOR ASSEMBLY LH

(a) Remove the 2 screws and remove the visor assembly LH.

93. REMOVE VISOR BRACKET COVER (for RH Side)

HINT
Use the same procedure for the RH side and the LH side.

94. REMOVE VISOR ASSEMBLY RH

HINT
Use the same procedure for the RH side and the LH side.

95. REMOVE INNER REAR VIEW MIRROR STAY HOLDER COVER (w/ EC Mirror) Removal

96. REMOVE NO. 1 ROOM LIGHT ASSEMBLY (for Standard)

(a) Using a screwdriver, disengage the 4 claws and remove the lens cover.

HINT
Tape the screwdriver tip before use.

(b) Using a screwdriver, disengage the 2 claws [A] as shown in the illustration.

HINT
Tape the screwdriver tip before use.

(c) Disengage the 2 claws [B].

(d) Using a screwdriver, disengage the 4 claws and remove the No. 1 room light assembly.

97. REMOVE NO. 1 ROOM LIGHT ASSEMBLY (for Independent Type)

(a) Using a screwdriver, disengage the 4 claws and remove the lens cover.

HINT
Tape the screwdriver tip before use.

(b) Using a screwdriver, disengage the 2 claws [A] as shown in the illustration.

HINT
Tape the screwdriver tip before use.

(c) Disengage the 2 claws [B].

(d) Using a screwdriver, disengage the 8 claws and remove the No. 1 room light assembly.

98. REMOVE NO. 2 ROOM LIGHT ASSEMBLY

(a) Using a screwdriver, disengage the 4 claws and remove the lens cover.

HINT
Tape the screwdriver tip before use.

(b) Using a screwdriver, disengage the 2 claws [A] as shown in the illustration.

HINT
Tape the screwdriver tip before use.

(c) Disengage the 2 claws [B].

(d) Using a screwdriver, disengage the 4 claws and remove the No. 2 room light assembly.

99. REMOVE TELEVISION BASE (w/ Rear Seat Entertainment System) Removal

100. REMOVE TELEVISION DISPLAY ASSEMBLY (w/ Rear Seat Entertainment System) Removal

101. REMOVE FRONT ASSIST GRIP SUB-ASSEMBLY (w/o Sliding Roof)

(a) Using a clip remover, disengage the 4 claws.

NOTICE:
Do not forcibly pry the assist grip covers to prevent them from being deformed.

HINT
* Gently pry on the assist grip covers as shown in the illustration to remove them.
* Tape the clip remover tip before use.
(b) Pull off the 2 assist grip covers by hand.

(c) Disengage the 2 clips and remove the front assist grip sub-assembly.

(d) Remove the 2 clips from the vehicle body.

HINT
Use the same procedure for the RH side and the LH side.

102. REMOVE REAR ASSIST GRIP SUB-ASSEMBLY (w/o Sliding Roof)

(a) Using a clip remover, disengage the 4 claws.

(d) Remove the 2 clips from the vehicle body.

HINT
Use the same procedure for the RH side and the LH side.

103. REMOVE ASSIST GRIP ASSEMBLY (w/ Sliding Roof)

(a) Using a screwdriver, disengage the 6 claws and remove the 2 assist grip covers.

NOTICE:
Do not forcibly pry the assist grip covers to prevent them from being deformed.

HINT
Tape the screwdriver tip before use.

(b) Disengage the 4 clips and remove the assist grip assembly.

(c) Remove the 4 clips from the vehicle body.

HINT
Use the same procedure for the other 4 assist grips.

104. REMOVE ROOF HEADLINING TRIM CLIP STOPPER

(a) Using a screwdriver, disengage the 3 claws.

HINT
Tape the screwdriver tip before use.

(b) Remove the bolt and the roof headlining trim clip stopper.

HINT
Use the same procedure for the RH side and the LH side.

105. REMOVE SUN ROOF OPENING TRIM MOULDING (w/ Sliding Roof)

106. REMOVE VISOR HOLDER

(a) Turn the visor holder approximately 45° and pull it out as shown in the illustration.

(b) Disengage the 2 claws and remove the visor holder.

HINT
Use the same procedure for the RH side and the LH side.

107. REMOVE ROOF HEADLINING ASSEMBLY (w/o Sliding Roof)

(a) Disconnect the No. 1 roof wire connector and disengage the 3 clamps from the front pillar LH.

(b) for Pole Antenna Type with Satellite Radio:

(1) Disconnect the No. 2 antenna cord sub-assembly connector and disengage the 2 clamps from the front pillar RH.

(c) except Pole Antenna Type without Satellite Radio:

(1) Disconnect the No. 2 antenna cord sub-assembly connector, disengage the 3 clamps and remove the bolt from the front pillar RH.

(d) for Pole Antenna Type with Satellite Radio:

(1) Disconnect the No. 2 antenna cord sub-assembly connector and disengage the clamp from the rear pillar RH.

(e) except Pole Antenna Type without Satellite Radio:

(1) Disconnect the No. 2 antenna cord sub-assembly connector from the rear pillar RH.

(f) except Pole Antenna Type with Satellite Radio:

(1) Disconnect the No. 2 antenna cord sub-assembly each connector and disengage the clamp from the rear pillar RH.

(g) Remove the 4 clips.

(h) Remove the roof headlining assembly from the vehicle through the back door.

NOTICE:
Do not damage the roof headlining assembly or body interior.

108. REMOVE ROOF HEADLINING ASSEMBLY (w/ Sliding Roof)

(a) Disconnect the No. 1 roof wire connectors and disengage the 3 clamps from the front pillar LH.

(b) w/ Rear Seat Entertainment System:

(1) Disconnect the No. 1 roof wire connector from the rear pillar LH.

(c) for Pole Antenna Type with Satellite Radio:

(1) Disconnect the No. 2 antenna cord sub-assembly connector and disengage the 2 clamps from the front pillar RH.

(d) except Pole Antenna Type with Satellite Radio:

(1) Disconnect the No. 2 antenna cord sub-assembly connector and disengage the 3 clamps, and remove the bolt from the front pillar RH.

(e) for Pole Antenna Type with Satellite Radio:

(1) Disconnect the No. 2 antenna cord sub-assembly connector and disengage the clamp from the rear pillar RH.

(f) except Pole Antenna Type with Satellite Radio:

(1) Disconnect the No. 2 antenna cord sub-assembly connector from the rear pillar RH.

(g) except Pole Antenna Type with Satellite Radio:

(1) Disconnect the No. 2 antenna cord sub-assembly each connector and disengage the clamp from the rear pillar RH.

(h) Disconnect the sliding roof drive gear connector.

(i) Remove the 3 clips.

(j) Remove the roof headlining assembly from the vehicle through the back door.

NOTICE:
Do not damage the roof headlining assembly or body interior.

109. REMOVE VANITY LIGHT ASSEMBLY (w/ Vanity Light)

(a) Disengage the 2 claws [A] and separate the bulb holder from the vanity light assembly as shown in the illustration.

(b) Disengage the claw [B] and remove the vanity light assembly.

HINT
Use the same procedure to remove the light on the other side.

110. REMOVE FRONT SIDE RAIL SPACER LH (w/o Sliding Roof)

(a) Remove the front side rail spacer LH.

111. REMOVE FRONT SIDE RAIL SPACER RH (w/o Sliding Roof)

HINT
Use the same procedure for the RH side and the LH side.

112. REMOVE REAR NO. 2 SIDE RAIL SPACER LH (w/o Sliding Roof)

(a) Remove the rear No. 2 side rail spacer LH.

113. REMOVE REAR NO. 2 SIDE RAIL SPACER RH (w/o Sliding Roof)

HINT
Use the same procedure for the RH side and the LH side.

114. REMOVE NO. 1 ROOF SILENCER PAD (w/o Sliding Roof)

(a) Remove the No. 1 roof silencer pad.

115. REMOVE NO. 2 ROOF SILENCER PAD (w/o Sliding Roof)

(a) Remove the No. 2 roof silencer pad.

116. REMOVE NO. 1 ROOF HEADLINING SUPPORT

(a) Remove the 2 No. 1 roof headlining supports.

117. REMOVE ROOF HEADLINING PAD

(a) Remove the 2 roof headlining pads.

118. REMOVE NO. 2 ROOF HEADLINING PAD

(a) Remove the 2 No. 2 roof headlining pads.

119. REMOVE NO. 4 ROOF SILENCER PAD

(a) Remove the No. 4 roof silencer pad.

120. REMOVE NO. 2 ROOF HEADLINING SUPPORT

(a) Remove each No. 2 roof headlining support.

121. REMOVE NO. 1 AIR OUTLET REGISTER ASSEMBLY (w/ Rear Air Conditioning System)

(a) Disengage the 10 claws, and remove the No. 1 air outlet register assembly from the roof side outlet register.

122. REMOVE NO. 1 ROOF WIRE

(a) w/ Vanity Light:

(1) Turn the visor connectors counterclockwise approximately 90° and disconnect the connectors from the roof headlining assembly.

(b) Remove the No. 1 roof wire from the roof headlining assembly.

(c) Remove the double-sided tape from the roof headlining assembly.

123. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY Removal

124. REMOVE ROOF SIDE RAIL GARNISH PAD RH (w/ Sliding Roof)

(a) Remove the roof side rail garnish pad RH.

125. REMOVE ROOF SIDE RAIL GARNISH PAD LH (w/ Sliding Roof)

(a) Remove the roof side rail garnish pad LH.

126. REMOVE REAR ROOF SIDE RAIL PAD RH (w/ Sliding Roof)

(a) Remove the rear roof side rail pad RH.

127. REMOVE REAR ROOF SIDE RAIL PAD LH (w/ Sliding Roof)

(a) Remove the rear roof side rail pad LH.