Removal

DOOR LOCK: REAR DOOR LOCK: REMOVAL

1. DISCONNECT NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation Service Precautions

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL Disassembly

3. REMOVE REAR DOOR ARMREST UPPER BASE PANEL Disassembly

4. REMOVE DOOR ASSIST GRIP COVER Disassembly

5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

6. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP Disassembly

7. REMOVE REAR DOOR SERVICE HOLE COVER Disassembly

8. REMOVE REAR DOOR WEATHERSTRIP Disassembly

9. REMOVE REAR DOOR GLASS RUN Disassembly

10. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY Disassembly

11. REMOVE REAR DOOR QUARTER WINDOW GLASS Disassembly

12. REMOVE REAR DOOR GLASS SUB-ASSEMBLY Disassembly

13. REMOVE REAR DOOR LOCK ASSEMBLY

(a) Using a "TORX" socket wrench (T30), remove the 3 screws.





(b) Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame.

(c) Remove the door lock wiring harness seal from the rear door lock assembly.

14. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

(a) Using a screwdriver, disengage the claw.





HINT
Tape the screwdriver tip before use.

(b) Remove the rear door lock remote control cable assembly.





15. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

(a) Using a screwdriver, disengage the 3 claws.





HINT
Tape the screwdriver tip before use.

(b) Remove the rear door inside locking cable assembly.