Tire Pressure Warning Reset Switch

TIRE PRESSURE WARNING RESET SWITCH

By operating the tire pressure warning reset switch, the tire pressure warning ECU can be set to issue a warning at an inflation pressure that corresponds to the standard pressure of tires.

Therefore, the dealer must set the warning threshold to the proper value in order to comply with the local regulations.

Operate the tire pressure warning reset switch only after the inflation pressures of all tires have been adjusted on the vehicle.

To initialize the system, press and hold the tire pressure warning reset switch for 3 seconds or longer with the ignition switch on (IG). After the initialization process has started, the warning light blinks 3 times (1 second on, 1 second off).

During initialization, the tire pressure warning valve and transmitter measures the inflation pressure of the tire, and registers the signals that are transmitted into the tire pressure warning ECU at a frequency of once per 3 minutes. The initialization process is completed when signals from all the tires have been received. It takes a few minutes.